LTJ Suspension clamp series

Cast body suspension clamp with a V groove, two nylon-insert studs and a rubber pad between body and conductor.

  • Model: LTJ
  • Product Type: Suspension Clamp

LTJ is a cast body clamp with a V-shaped conductor groove, two studs with nylon-insert nuts, and a rubber pad that sits between the body and the conductor. The body is inclined rather than symmetrical.

Where it is used

It holds an insulated overhead conductor at a support point, with the inclined body following the angle of the span. The rubber pad is there to keep the insulation from being crushed at the point of contact.

How it holds the conductor

Two studs close the body onto the conductor through the rubber pad. The nylon insert in the nut is what stops the joint loosening under vibration — a plain nut on a clamp that sees wind movement will back off.

Fixing and installation

Seat the conductor in the groove with the pad in place, then tighten the two nuts evenly and alternately so the body closes square. Tightening one side fully first tilts the body and puts all the load on one edge of the pad.

How to Select the Right Model

Confirm when ordering:

ParameterValue
Conductor outside diameterMust sit inside the V groove with the pad fitted
Fixing interfaceHow the body attaches to the bracket or hook
Stud and nutThreaded studs with nylon-insert nuts
PadRubber
Breaking loadConfirmed per order — see the note below

The fixing interface on this body is not visible enough on the photos to state it here. Send the bracket or hook you intend to use and we confirm the match.

Sending an enquiry for LTJ

One message with the conductor size, the pole or wall fixing and the quantity is enough for us to come back with the model, the grip value and a price. Drawings are welcome in place of a written description.

Request a quotation

Send us the cable type and size, quantity and destination port for a quotation with pricing and lead time. View all suspension clamp models →

Chat on WhatsApp +86-15825688289 salesmanager@ggldf.com