5D-93 Tension clamp series
Wedge-type aluminium alloy tension clamp for terminating bare and insulated overhead conductor at dead-end and angle poles.
- Model: 5D-93
- Product Type: Tension Clamp
5D-93 is a wedge-type tension clamp cast in aluminium alloy. The conductor runs through a tapered channel in the body, a separate wedge is driven in behind it, and the bolts pull the two halves together. Grip therefore increases with the pull on the conductor rather than depending on a fixed bolt torque.
Where it is used
It terminates bare or insulated overhead conductor at dead-end and angle poles on distribution lines, and anchors service drops where a bolted termination is preferred to a compression fitting. The eye at the tail takes a clevis, a thimble or an insulator pin.
How it holds the conductor
The wedge presses the conductor along the full length of the taper instead of biting it at one point, so the strands are compressed rather than nicked. Body and wedge are cast in aluminium alloy; the bolts, clevis pin and cotter pin are galvanised steel. The cotter pin is what keeps the clevis pin from walking out under vibration.
Fixing and installation
Lay the conductor into the channel, seat the wedge by hand, drive it home, then torque the bolts in sequence from the middle outwards. A wedge that has already been driven and released should not be re-used — the seating marks left on it reduce the grip on a second pull.
Filed under suspension clamps on this site, but 5D-93 is a tension (dead-end) clamp — it carries the full pull of the span, it does not support the conductor in mid-span.
How to Select the Right Model
Sizing follows the conductor, not the clamp catalogue:
| Parameter | Value |
|---|---|
| Conductor size and material | State the size; size is not fixed in this listing |
| Rated tensile strength of the conductor | Needed to set the grip requirement |
| Body and wedge | Aluminium alloy |
| Bolts, clevis pin, cotter pin | Galvanised steel |
| Stripped or insulated conductor | State which; it changes the clamp body |
A grip figure printed without the conductor it applies to is not usable. Send the conductor type, size and rated tensile strength and we confirm both the model and the grip value in writing before the order is placed.
Sending an enquiry for 5D-93
One message with the conductor size, the pole or wall fixing and the quantity is enough for us to come back with the model, the grip value and a price. Drawings are welcome in place of a written description.
Send us the cable type and size, quantity and destination port for a quotation with pricing and lead time. View all suspension clamp models →










