
PA2/25 Plastic Tension Clamp
The PA2/25 polymer tension clamp terminates 2-core 10-35 mm² LV-ABC conductors with insulated neutral messengers, rated 2.5 kN breaking load.
- Model: PA2/25
- Product Type: Plastic Tension Clamp
- Cross-Section / Cable Range: 2x10-35mm²
- Breaking Load: 2.5kN
Product Description
The PA2/25 is a polymer-bodied tension clamp for anchoring and dead-ending LV-ABC lines with an insulated neutral messenger. The insulated neutral carries the mechanical tension, and this clamp terminates it together with the phase conductors.
The body is reinforced polymer, which gives it good UV resistance while staying light enough to install by hand on a pole. No special tooling is needed.
Because the neutral messenger is insulated, the clamp must grip the insulation without damaging it — the wedge profile spreads the clamping force along the messenger so the jacket is not crushed. Rated 2.5kN breaking load.
Technical Specifications
| Item | Specification |
| Model | PA2/25 |
| Product Type | Plastic Tension Clamp |
| Cross-Section / Cable Range | 2×10-35mm² |
| Breaking Load | 2.5kN |
| Product Category | Aerial Cable Accessories |
| Manufacturer | GGLDF |
How to Select the Right Model
Two things decide which model fits: the number of conductors and their cross-section. The range is written as core count × conductor range — for example 4×16-25mm² means four conductors of 16 to 25 mm² each.
| Model | Conductor range | Breaking load | Core |
| PA2/25 | 2×10-35mm² | 2.5kN | 2-core |
| PA4/25 | 4×16-25mm² | 2.5kN | 4-core |
| PA-25S | 4×16-25mm² | 2.5kN | 4-core |
| PA16~95 | 4-120mm² | 2.5kN | single / mixed |
| PA16 | 10-70 mm² | 3kN | single / mixed |
| PA-903 | 25-70/2×10-25mm² | 1.5kN | single / mixed |
| PA1500 | 50-70mm² | 6kN | single / mixed |
| PA2000 | 70-95mm² | 6kN | single / mixed |
Match both the core count and the section, then check that the breaking load is adequate for the span. If your conductors fall outside every row, send us the core count and cross-section and we will confirm the model rather than guess.
Plastic or metal? polymer bodies are lighter and easier to install, but metal bodies carry a higher breaking load. On longer spans or heavier conductors, choose the metal-bodied model in this range.
Key Advantages
- Lightweight reinforced polymer body — installed by hand, no special tooling
- UV resistant, so the clamp does not degrade in prolonged sunlight
- Wedge profile spreads clamping force and avoids crushing the messenger insulation
- Rated 2.5kN breaking load
Typical Applications
- Dead-end and anchor termination of LV-ABC lines with insulated neutral messengers.
- Strain locations where the full messenger tension must be absorbed.
- Short-span terminations on distribution poles.
- Overhead distribution line construction and maintenance.
Send us the core count, conductor cross-section, quantity and destination port for a quotation with pricing and lead time. View all tension clamp models →
