PAL1500D Tension Clamp for Round Cables

The PAL1500D is an aluminium alloy tension clamp (dead-end clamp) for round conductors of 12-15 mm diameter, rated 15 kN breaking load, used for anchor termination on overhead distribution lines.

  • Model: PAL1500D
  • Cable Diameter: 12-15mm
  • Breaking Load: 15kN

Product Description

The PAL1500D is a tension clamp (dead-end clamp) used to anchor a round conductor at the termination point of an overhead distribution line. The conductor is held along the full length of the clamp, so the mechanical tension of the line is transferred into the clamp body instead of concentrating on a single point of the conductor surface.

Because the gripping force is distributed over the conductor length rather than applied at one point, the conductor surface is less likely to deform or nick under sustained tension. The clamp is fitted by hand at strain and dead-end locations, typically on the last span before a pole, tower or switch structure.

This model is dimensioned by conductor diameter (12–15 mm) rather than by cross-section, which is how this particular variant is specified. If your drawings give a cross-section in mm² instead of a diameter, check the selection table below before ordering.

Technical Specifications

ItemSpecification
ModelPAL1500D
Product TypeTension Clamp for Round Cables (Dead-end Clamp)
Conductor Diameter12–15 mm
Breaking Load15 kN
MaterialAluminium alloy body with Nylon PA66
Product CategoryAerial Cable Accessories
ManufacturerGGLDF

How to Select the Right Model

The PAL series is divided by conductor size. Note that most models are dimensioned by cross-section, while PAL1500D is dimensioned by diameter — confirm which unit your specification uses.

Your specificationModelRated breaking load
16–35 mm²PAL1000A10 kN
25–50 mm²PAL100012 kN
35–70 mm²PAL150015 kN
Round conductor, 12–15 mm diameterPAL1500D15 kN
70–150 mm²PAL200018 kN
FTTH drop cableODWAC seriesSee ODWAC pages

If the conductor size falls between two ranges, choose the larger clamp and confirm the conductor diameter fits inside the clamp bore before ordering.

Key Advantages

  • Distributed grip along the conductor length reduces surface deformation compared with single-point clamps
  • Rated 15 kN breaking load for standard LV overhead distribution
  • Aluminium alloy body with Nylon PA66 contact parts, suited to outdoor service
  • Fitted without a special tool — the clamp is shaped to the conductor and installed by hand

Typical Applications

  • Dead-end and anchor termination of overhead distribution conductors.
  • Strain locations where the full conductor tension must be absorbed.
  • Span termination before poles, towers or switch structures.
  • Conductor end anchoring where the line terminates and no further span follows.

Send us the conductor size, quantity and destination port for a quotation with pricing and lead time. View all tension clamp models →

Chat on WhatsApp +86-15825688289 salesmanager@ggldf.com