
PA2/35 Metal Tension Clamp
The PA2/35 metal tension clamp terminates 2-core 16-35 mm² LV-ABC conductors, rated 5 kN breaking load. Aluminium alloy body with stainless steel fasteners.
- Model: PA2/35
- Product Type: Metal Tension Clamp
- Cross-Section / Cable Range: 2x16-35mm²
- Breaking Load: 5kN
Product Description
The PA2/35 is a metal tension clamp used to anchor and terminate LV-ABC lines on overhead distribution networks. It grips the conductors along the clamp body so the full mechanical tension of the span transfers into the clamp rather than into the cable.
The body is aluminium alloy with stainless steel fasteners, which gives it a higher breaking load than the polymer-bodied clamps in this range. That matters on longer spans or heavier conductors, where a lower-rated clamp can deform or pull free.
Install by hand. Rated 5kN breaking load.
Technical Specifications
| Item | Specification |
| Model | PA2/35 |
| Product Type | Metal Tension Clamp |
| Cross-Section / Cable Range | 2×16-35mm² |
| Breaking Load | 5kN |
| Product Category | Aerial Cable Accessories |
| Manufacturer | GGLDF |
How to Select the Right Model
Two things decide which model fits: the number of conductors and their cross-section. The range is written as core count × conductor range — for example 4×16-35mm² means four conductors of 16 to 35 mm² each.
| Model | Conductor range | Breaking load | Core |
| PA2/35 | 2×16-35mm² | 5kN | 2-core |
| PA4/35 | 2×16-35mm² | 5kN | 2-core |
| GD160 | 2×16-35mm² | 5kN | 2-core |
| PA4/16~35 | 4×16-35mm² | 12kN | 4-core |
| GD161 | 4×16-35mm² | 5kN | 4-core |
| RPA425/70 | 4×16-50mm² | 20kN | 4-core |
| NES-1S | 4×16-50mm² | 20kN | 4-core |
| NES-2S | 4×50-120mm² | 20kN | 4-core |
| JBG-50-1000 | 25-50mm² | 10kN | single / mixed |
Match both the core count and the section, then check that the breaking load is adequate for the span. If your conductors fall outside every row, send us the core count and cross-section and we will confirm the model rather than guess.
Key Advantages
- Rated 5kN breaking load — higher capacity than the polymer-bodied clamps in this range
- Aluminium alloy body with stainless steel fasteners, suited to outdoor service
- Distributes tension along the conductors instead of concentrating it at one point
- Fitted without special tooling
Typical Applications
- Dead-end and anchor termination of LV-ABC overhead distribution lines.
- Strain locations where the full conductor tension must be absorbed.
- Span termination before poles, towers or switch structures.
- Overhead distribution line construction and maintenance.
Send us the core count, conductor cross-section, quantity and destination port for a quotation with pricing and lead time. View all tension clamp models →
