
PAL1500D Tension Clamp for Round Cables
The PAL1500D is an aluminium alloy tension clamp (dead-end clamp) for round conductors of 12-15 mm diameter, rated 15 kN breaking load, used for anchor termination on overhead distribution lines.
- Model: PAL1500D
- Cable Diameter: 12-15mm
- Breaking Load: 15kN
Product Description
The PAL1500D is a tension clamp (dead-end clamp) used to anchor a round conductor at the termination point of an overhead distribution line. The conductor is held along the full length of the clamp, so the mechanical tension of the line is transferred into the clamp body instead of concentrating on a single point of the conductor surface.
Because the gripping force is distributed over the conductor length rather than applied at one point, the conductor surface is less likely to deform or nick under sustained tension. The clamp is fitted by hand at strain and dead-end locations, typically on the last span before a pole, tower or switch structure.
This model is dimensioned by conductor diameter (12–15 mm) rather than by cross-section, which is how this particular variant is specified. If your drawings give a cross-section in mm² instead of a diameter, check the selection table below before ordering.
Technical Specifications
| Item | Specification |
| Model | PAL1500D |
| Product Type | Tension Clamp for Round Cables (Dead-end Clamp) |
| Conductor Diameter | 12–15 mm |
| Breaking Load | 15 kN |
| Material | Aluminium alloy body with Nylon PA66 |
| Product Category | Aerial Cable Accessories |
| Manufacturer | GGLDF |
How to Select the Right Model
The PAL series is divided by conductor size. Note that most models are dimensioned by cross-section, while PAL1500D is dimensioned by diameter — confirm which unit your specification uses.
| Your specification | Model | Rated breaking load |
| 16–35 mm² | PAL1000A | 10 kN |
| 25–50 mm² | PAL1000 | 12 kN |
| 35–70 mm² | PAL1500 | 15 kN |
| Round conductor, 12–15 mm diameter | PAL1500D | 15 kN |
| 70–150 mm² | PAL2000 | 18 kN |
| FTTH drop cable | ODWAC series | See ODWAC pages |
If the conductor size falls between two ranges, choose the larger clamp and confirm the conductor diameter fits inside the clamp bore before ordering.
Key Advantages
- Distributed grip along the conductor length reduces surface deformation compared with single-point clamps
- Rated 15 kN breaking load for standard LV overhead distribution
- Aluminium alloy body with Nylon PA66 contact parts, suited to outdoor service
- Fitted without a special tool — the clamp is shaped to the conductor and installed by hand
Typical Applications
- Dead-end and anchor termination of overhead distribution conductors.
- Strain locations where the full conductor tension must be absorbed.
- Span termination before poles, towers or switch structures.
- Conductor end anchoring where the line terminates and no further span follows.
Send us the conductor size, quantity and destination port for a quotation with pricing and lead time. View all tension clamp models →
