Blog

Product Knowledge Aeolian Vibration on Overhead Lines: Causes and Control

Aeolian Vibration on Overhead Lines: Causes and Control

Aeolian vibration leaves almost no trace until someone opens a suspension clamp and finds the outer aluminium strands cut through. The conductor looks straight, the sag is correct, the clamps went on to drawing, and the line has been fatiguing itself for years at an amplitude of about one conductor diameter — movement nobody notices […]
Product Knowledge Incoming Inspection: Checking a Shipment of Line Hardware

Incoming Inspection: Checking a Shipment of Line Hardware

Incoming inspection of line hardware is the point where a purchase order either becomes accepted stock or becomes a documented claim. A large share of the fittings that fail early in service were not damaged in service at all. They arrived with a coating already breached, a thread flattened by a forklift fork, a clamp […]
Product Knowledge How to Specify Overhead Line Fittings in an RFQ

How to Specify Overhead Line Fittings in an RFQ

Most requests for quotation for overhead line fittings do not fail on price. They fail on data. A buyer sends a list that reads “tension clamps 200 sets, suspension clamps 300 sets, delivery 60 days” and receives back not a quotation but a page of questions: which conductor, what outer diameter, what span, what string, […]
Product Knowledge Overhead Line Fittings Inspection: What to Check, When to Replace

Overhead Line Fittings Inspection: What to Check, When to Replace

Overhead line fittings inspection is most useful when it does more than produce photographs. A good patrol separates harmless appearance changes from defects that can release a conductor, create a high-resistance joint, damage strands, or allow vibration to spread. It also tells the maintenance planner what needs immediate replacement, what can enter a planned outage, […]
Product Knowledge Aerial Bundled Cable Fittings: What One Run Needs

Aerial Bundled Cable Fittings: What One Run Needs

An aerial bundled cable run is not bought as a product. It is bought as a set of positions: every pole where the bundle terminates, every pole where it merely passes through, every service drop that leaves it, every place two lengths meet, and every place the insulation has to be closed again afterwards. Each […]
Product Knowledge How to Install a Tension Clamp: Compression, Bolted, Wedge

How to Install a Tension Clamp: Compression, Bolted, Wedge

A dead-end tension clamp transfers the full working tension of a conductor span into a pole, tower or termination structure. Unlike a support fitting, it must do that without slipping along the conductor, crushing the strand, or creating a resistance problem at the interface. For the crew and the inspector, the clamp is either correctly […]
Chat on WhatsApp +86-15825688289 salesmanager@ggldf.com