Product Knowledge

Product Knowledge Line Fitting Materials: Galvanised Steel, Aluminium, Stainless

Line Fitting Materials: Galvanised Steel, Aluminium, Stainless

When buyers compare line fittings, the conversation usually stops at the model number: which tension clamp, which suspension clamp, which size range. The material the fitting is made from rarely gets a question of its own — and yet material decides how heavy the fitting is, how it corrodes, whether it plays nicely with the […]
Product Knowledge When Not to Use an Insulation Piercing Connector

When Not to Use an Insulation Piercing Connector

Insulation piercing connectors are the most convenient fitting on a distribution van. No cable stripping, no crimping tool, one bolt to tighten, and the branch is live in under a minute. That convenience is why they end up on joints they were never intended for — a heavy branch here, a mismatched conductor there, a […]
Product Knowledge Guy and Stay Assemblies: What a Complete Stay Set Includes

Guy and Stay Assemblies: What a Complete Stay Set Includes

A guy wire is only as strong as the weakest fitting threaded onto it. On an overhead line, the guy does not work alone: it transfers the entire lateral load of a pole, a corner, or a dead-end into the ground through a chain of hardware, and every link in that chain — anchor rod, […]
Product Knowledge Spacers and Spacer Dampers for Bundled Conductors

Spacers and Spacer Dampers for Bundled Conductors

A bundled conductor solves one problem and creates another. Splitting a phase into two, three, four or more sub-conductors raises the effective diameter of the phase, which cuts corona loss and audible noise, and lowers reactance, which is why most lines above a certain voltage use bundles. The moment those sub-conductors hang side by side […]
Product Knowledge Infrared Thermography for Line Joints: Finding Hot Spots

Infrared Thermography for Line Joints: Finding Hot Spots

Every joint on an overhead line — tension clamp, mid-span compression sleeve, parallel groove clamp, bolted terminal, insulation piercing tap — is an electrical connection first and a mechanical assembly second. The moment its contact resistance rises, the joint starts converting transport current into heat, and it keeps doing so quietly for months. Nothing looks […]
Product Knowledge Conductor Repair: Sleeves, Patches and When to Restring

Conductor Repair: Sleeves, Patches and When to Restring

A damaged conductor rarely fails at the moment somebody spots it. It fails later, when load, wind, or a temperature swing pushes a strand that has already lost part of its section past what it can carry. The decision after a patrol report is therefore not simply “fix it or leave it”, but a graded […]
Chat on WhatsApp +86-15825688289 salesmanager@ggldf.com